RING JOINT GASKET come in two basic types, an oval cross section and an octagonal cross section .These basic shapes are used in pressures up to 10,000 psi.
The dimensions are standardized and require specially grooved flanges. The octagonal cross section has a higher sealing efficiency than.
You can buy high quality Ring Joint Gasket at low prices from our factory.
The High Temperature IX Ring Joint Gasketre designed and used where the NORSOK CFC (Compact Flange Connections) are in use. The rings come in three different kinds of steel and are coated with PTFE in varying colours in order to distinguish between them. Standard identification NORSOK STANDARD L-005 (NCF5).
A Inconel Ring Joint Gasketis a line contact seal for use in high pressure piping systems and in pressure vessel heads. The lens cross section is a spherical gasket surface and requires special machining on the flanges. These gaskets will seat with a small bolt load since the contact area is very small...
RX Ring Joint Gasketare designed for API 6 BX flange grooves only,it is suitable for higher-pressure ratings starting at 2,000 lbs and ending with 20,000 lbs,incorporate a pressure balance hole to ensure equalization of pressure which may get trapped in the grooves.
BX Ring Joint Gasket are manufactured to fit the API 6B flange"s groove,interchangeable with R(oval) and R(octagonal) series,bear pressure can reach to 15000 PSI,so these gaskets performance excellent in 6B flange, suitable to the higher pressures with higher vibrations and heavier...
Ring Type Joint-Octagonal is machined from solid metal in a variety of shapes according to API 6A & ASME B16.20 standards,it’s designed for high pressure ,high temperature or highly corrosive applications by selecting the most suitable material and shape. It is designed to with stand exceptionally high assembly loads over a small area, thus producing high seating stresses.
Ring Type Joint-Oval is machined from solid metal in a variety of shapes according to API 6A & ASME B16.20 standards,it’s designed for high pressure ,high temperature or highly corrosive applications by selecting the most suitable material and shape. It is designed to with stand exceptionally high assembly loads over a small area, thus producing high seating stresses
